Creating a Binding Margin
Follow the procedure below to print with a binding margin. If you create a binding margin, it is offset from the document margin set from the application.
Since the margin opposite the binding margin will be shifted toward the paper edge, be sure to make this margin wide enough when making the document.
If a binding margin is set in an application, do not make this setting in the printer properties. This would result in a binding margin twice as wide as expected.
Open the file you want to print from the application, and then open the printer properties dialog box.
Click the [Edit] tab.
Select the [Header/Footer/Adjust image position/Binding margins] check box.
Click [Details...].
The [Header/Footer/Adjust Image Position/Binding Margins] dialog box appears.
In the [Adjust Image Position] area, select the direction in which you want to shift the print area in the [Direction:] list.
Margins (top, bottom, left, right) change according to the selected direction.
Enter a binding margin width, and then click [OK].
To change the measurement unit, click [Measurement Unit...].
Make the necessary settings, and then click [OK].
The printer properties dialog box closes.
Make print settings, and then click [OK].
